Find content
Male
mr3cho, on Yesterday, 12:52 , said:
VocalNeal, on Yesterday, 10:45 , said:
1-One has to assume they are all the same. You didn't notice that when you sat in the vehicle before purchasing. Had you have noticed would you not have bought the vehicle?
2-A new rubber thingy can be fitted.
3-The centre consle lid will probably be given some "English" and will then close.
4-Again you didn't notice the useless cup holders when you were overcome with desire?
5-The wires follow the frame rail and will be clipped in. Normal.
Instead of simply using and enjoying your new purchase you have examined it with a fine toothed comb AFTER you purchased it. Best advice would be forge.t. Go Buddhist and forget all these minor flaws and be thankful you are getting go service from the dealer.
2-A new rubber thingy can be fitted.
3-The centre consle lid will probably be given some "English" and will then close.
4-Again you didn't notice the useless cup holders when you were overcome with desire?
5-The wires follow the frame rail and will be clipped in. Normal.
Instead of simply using and enjoying your new purchase you have examined it with a fine toothed comb AFTER you purchased it. Best advice would be forge.t. Go Buddhist and forget all these minor flaws and be thankful you are getting go service from the dealer.
No man I don't think he should forget it. Those are some QC problems and the OP should complain up the chain because if he ( and others ) don't , the QC problems won't get fixed. It's difficult to examine everything when you take delivery. This is has to do with being promised a product and service for his hard earned money and not receiving what was promised.
How do you know he worked hard for his money? What a load of tosh. For all we know he didn't pay and has it on credit. He may not but that is none of our business.
He is getting good service from the dealer.
Yes it is difficult to examine everything when one takes delivery that is why one has to look closely before deciding to buy. Cup holders in the bed cannot be used ? Well if that is a reason to purchase then look closely to see if they work. Some people have been known not to buy cars because there were no astrays in the back. 15mm gap around the ignition switch would be obvious when sitting in one in the showroom. If these are to be viewed as flaws then they are design flaws not QC and already known to the manufacturer as they inspect their vehicles much more closely than we do. Why is there a 15mm gap I don't know why do the cup holders not work I do not know. But someone does.
Missing door bumper and non latching centre console are the only two I see as being "QC" problems and has been said they will be addressed at the first service.
